U.S. Hypertherm plasma produced by a thin material cutting machine is a low-cost solution for gouging, for pipe cutting machines, robots, or three-dimensional cutting and pipe cutting and bevel cutting occasions. It uses dry plasma, single-gas process. 

 Powermax600 output current can be adjusted between 20-40 amps, the maximum output power of 5.6kw, low-cost compressed air or nitrogen can be used as a plasma gas source, with the organic with hand-held torch cutting torch or two for users to choose. Non-high-frequency guiding arc, with rapid removal of the cutting torch, cutting torch used machine with CNC interface. Hand-held torch, it uses a number of exclusive ownership of the technology, account for all aspects of leadership, a patented nozzle technology that can easily drag cutting, easily controlled; a small error tolerance patented hafnium metal processing technology improves the life of wearing parts. 

 Cutting Capacity 

 Machine system: handheld system: the thinnest - Recommended - the largest 

 Low-carbon steel cutting 0.5mm-3mm mild steel cutting 0.5mm-10mm-16mm 

 Stainless steel cutting 0.5mm-3mm stainless steel cutting 0.5mm-10mm-16mm 

 Aluminum cutting 1.0mm-3mm aluminum cutting 1.0mm-10mm-16mm 

 Machine system temporarily set was 100% and 50% duty cycle was increased cutting capacity doubled; handheld system temporarily set rate of 50%, the maximum production capacity of steel under the cutting speed of 330mm/min. Machine system under the maximum production capacity of carbon steel cutting speed 1680mm/min. 



 For gas 

 Plasma gas: air, nitrogen gas: not applicable 

 Inlet pressure 5.0bar flow 170 L / Min